Table of Contents
Advertisement
15
Installing the EHI Steering
Valve
Parts needed for this procedure:
1
Manifold mount
2
Flange-head capscrew (1/4 x 1/2 inch)
2
Washer (1/4 inch)
2
Flange locknut (1/4 inch)
2
U-bolt (3/8 inch)
4
Flange locknut (3/8 inch)
1
Model/serial decal
1
EHI steering valve
2
Straight hydraulic fitting (-6 x 12 mm)
4
Straight hydraulic fitting (-8 x 22 mm)
4
Straight hydraulic fitting (-6 x 18 mm)
3
Flange-head capscrew (8 x 16 mm)
Installing the Manifold Mount
1.
Align the manifold mount to the front of the
machine as shown in
Figure 66
1. Manifold mount
2.
Align the holes in the manifold mount with the
slots in the flange of the storage compartment
(Figure
67).
Note:
Ensure that the wires harness is
not pinched between the mount and the
compartment.
Figure
66.
g299717
1. Flange (storage
compartment)
2. Flange locknut (1/4 inch)
3. Washer (1/4 inch)
3.
Loosely assemble the manifold mount to the
flange
(Figure
(1/4 x 1/2 inch), 2 washers (1/4 inch), and 2
flange locknuts (1/4 inch).
4.
Loosely assemble the manifold mount to the
dash support tube
inch) and 4 flange locknuts (3/8 inch).
1. U-bolt (3/8 inch)
2. Dash support tube
5.
Tighten the capscrews, U-bolts, and locknuts.
Affixing the Model/Serial Decal
1.
Remove the backing from the model/serial
decal.
30
Figure 67
4. Flange-head capscrew
(1/4 x 1/2 inch)
5. Manifold mount
67) with 2 flange-head capscrews
(Figure
68) with 2 U-bolts (3/8
Figure 68
3. Manifold mount
4. Flange locknut (3/8 inch)
g299721
g299723
Advertisement
Table of Contents
