Removing The Can Bus Resistor; Installing The Adapter Harness And Terminating Resistor - Toro 138-6246 Installation Instructions Manual

10
Removing the CAN Bus
Resistor
No Parts Required
Removing the Console Side Panel
1. Lower the passenger seat.
2. Remove 4 flange-head capscrews (1/4 x 3/4
inch) that secure the side panel of the center
console as shown in
Figure 41
1. Side panel
3. Tilt the passenger seat forward, and remove the
lower rear flange-head capscrew
4. Remove the side panel from the center console.
Removing the Terminating
Resistor
Forward of the TEC Controller, remove the resistor
75Ω from the 3-socket connector (not labeled) of the
machine wire harness
Figure 41.
2. Flange-head capscrews
(1/4 x 3/4 inch)
(Figure
(Figure 42).
Note:
Retain the resistor for installation in
Installing the Adapter Harness and Terminating
Resistor (page
Note:
You will install the side panel to the center
console when you install the AutoSteer Kit for the
Multi Pro 5800 Turf Sprayer with GeoLink; refer to
the setup instructions in the AutoSteer kit Installation
Instructions.
1. TEC controller
2. 3-socket connector (not
labeled—machine wire
harness)
11
Installing the Adapter
Harness and Terminating
Resistor
Parts needed for this procedure:
1
Adapter harness—13 cm (5 inches)
g301406
1 Cable tie
Procedure
1. At the satellite receiver, remove the ISO bus
terminator for the 6-socket connector of the
41).
GeoLink harness
Note:
terminator.
22
22).
Figure 42
3. Resistor 75Ω (3-pin)
(Figure 43).
You no longer need the ISO bus
11
g308955