Removing The Steering Wheel And Steering Valve - Toro 138-6246 Installation Instructions Manual

Figure 43
1. 6-socket connector
(GeoLink harness)
2. Terminator (ISO bus)
2. Plug the 6-pin connector of the adapter
harness—13 cm (5 inches) into the 6-socket
connector of the GeoLink harness
3. Plug the resistor that you removed in
the Terminating Resistor (page 22)
3-socket connector of the adapter harness
(Figure 44).
Figure 44
1. 3-socket connector
(adapter harness)
g314512
3. 6-pin connector (adapter
harness)
(Figure 43).
Removing
into the
g308954
2. Resistor 75Ω (3-pin)
4. Secure the adapter harness to the GeoLink
harness with a cable tie.
12
Removing the Steering
Wheel and Steering Valve
No Parts Required
Removing the Steering Wheel
1. Remove the cover from the steering wheel
(Figure 45).
1. Shaft (steering valve)
2. Steering wheel
3. Washer (5/8 inch)
2. Remove the nut (5/8 inch) and washer (5/8 inch)
securing the steering wheel to the shaft of the
steering valve
3. Remove the steering wheel from the
steering-valve shaft
Note:
Retain the nut, washer, steering wheel,
and cover.
Removing the Valve
1. Remove the 2 capscrews and 2 locknuts that
secure the hose guide to the flange of the
storage compartment, and remove the guide
(Figure 46).
Note:
Discard the capscrews, locknuts, and
hose guide.
23
Figure 45
4. Nut (5/8 inch)
5. Cover
(Figure 45).
(Figure 45).
g299130