Bolt (1/4-20 X 3/4 Inch); Locknut (1/4 Inch); Front Light Assembly; Right Front Light Bracket - Toro Outcross 9060 Series Installation Instructions Manual

4
Installing the Front Lights
Parts needed for this procedure:
6

Bolt (1/4-20 x 3/4 inch)

6

Locknut (1/4 inch)

2

Front light assembly

1

Right front light bracket

1

Left front light bracket

1

Wire harness

1

Push-mount fastener

Procedure
1. Determine the left and right position based on the normal operating position.
2. Attach the front
LEFT
3. Attach the front
RIGHT
4. Ensure that the yellow lens is on the outside (Box D of
1. Bolts —1/4-20 x 3/4 inch (6)
5. Attach the front light assemblies and brackets to both sides of the machine using 6 bolts (1/4-20 x 3/4
inch) and 6 nuts (1/4 inch) as shown in Boxes C and D in
6. Route and connect the wire harness as shown in
list assembly to the front
list assembly to the front
2. Nuts —1/4 inch (6)
light bracket (Box A of
LEFT
light bracket (Box B of
RIGHT
Figure 4).
Figure 4
Figure 4.
Figure 5.
5
Figure 4).
Figure 4).
3. Yellow lens
g278145