Table of Contents
Advertisement
Figure 75
1. Square hole (above the
prop-rod slot)
2. Mark 69 mm (2-11/16
inches)
3. Mark 45 mm (1-3/46
inches)
4.
Measure 45 mm (1-3/46 inches) inward from the
slotted flange of console base, and mark the
console base
(Figure
5.
Center punch the console base at the
intersection of the marks.
6.
Drill a hole in the console base at the
centerpunch mark with a 32 mm (1-1/4 inches)
drill bit
(Figure
75).
7.
Remove the sheet piece of sheet metal, and
remove any burrs around the hole.
8.
Install the grommet into the hole
g299798
4. Slotted flange (console
base)
5. Drill bit 32 mm (1-1/4
inches)
75).
(Figure
76).
1. Grommet
17
Installing the Electrical
Harness
Parts needed for this procedure:
1
2-position switch
1
Transport decal
1
Wire harness
7
Cable tie
1
Fuse (10 A)
1
Push-button switch, jam nut, and lock washer
1
AutoSteer remote-engage decal
Assembling the Road Switch to
the Dash
1.
Remove the plug in the dash panel as shown
in
Figure
77.
33
Figure 76
g299800
Advertisement
Table of Contents
