Table of Contents
Advertisement
Installing the Steering Wheel
1.
Ensure that the front tires are aligned forward.
2.
Apply a light coat of anti-seize compound to the
steering valve shaft.
3.
Align the large spoke of steering wheel down,
and assemble it over the shaft of the steering
valve
(Figure
53).
Figure 53
1. Shaft (steering valve)
2. Steering wheel
3. Washer (5/8 inch)
4.
Assemble the washer (5/8 inch) and nut (5/8
inch) onto the shaft
5.
Torque the nut to 27 to 35 N∙m (20 to 26 ft-lb).
6.
Assemble the cover onto the steering wheel
(Figure
53).
14
Removing the Steering
Valve Hoses
Parts needed for this procedure:
1
Cap
Removing the Hose Support
Clamps
1.
Under the floor plate, remove the nut (1/4 inch),
lock washer (1/4 inch), washer (3/8 x 7/8 inch),
and capscrew (1/4 x 7/8 inch) that secure the
clamp supporting the hydraulic hoses to the
clutch plate, and remove the clamp
4. Nut (5/8 inch)
5. Cover
(Figure
53).
(Figure
g299130
1. Hydraulic hoses
2. Clutch plate
3. Nut (1/4 inch)
4. Lock washer (1/4 inch)
2.
At the right side of the machine, remove the
flange locknuts (5/16 inch), carriage bolt (5/16 x
1 inch), and carriage bolt (5/16 x 1-1/2 inches)
that secure the 2 clamps supporting the return
hose of the steering valve to the engine mounts,
and remove the clamps
54).
26
Figure 54
5. Washer (3/8 x 7/8 inch)
6. Support clamp
7. Capscrew (1/4 x 7/8 inch)
(Figure
55).
g300044
g300053
Advertisement
Table of Contents
