Table of Contents
Advertisement
6
Removing the Hood
No Parts Required
Procedure
1.
Remove the headlight connector of the machine
wire harness from the connector of the headlight
bulb
(Figure
21).
Figure 21
1. Connector (machine
harness—headlight)
2.
Repeat step
1
at the other headlight.
3.
Remove the 4 push-in fasteners that secure
the bottom flange of the hood to the machine
(Figure
22).
Figure 22
1. Flange-head bolt (5/16 x
3/4 inch)
2. Flange (hood)
4.
Remove the 2 flange-head bolts (5/16 x 3/4 inch)
that secure the bottom flange to the machine
(Figure
22).
g298936
2. Connector (bulb)
g298939
3. Push-in fastener
5.
Remove the 4 Phillips pan-head screws (1/4 x 1
inch) that secures the hood to the dash support
(Figure
23).
1. Phillips pan-head screw
(1/4 x 1 inch)
2. Hood
6.
Remove the 2 push-in fasteners that secure the
hood to the dash support
7.
Remove the hood from the machine
Note:
Retain the hood, 2 flange-head bolts,
and 4 Phillips pan-head screws.
15
Figure 23
3. Push-in fastener
(Figure
23).
(Figure
Figure 24
g298940
24).
g298938
Advertisement
Table of Contents
