1. Pin locks (4)
5.
Connect the hydraulic hoses; refer to the traction unit Operator's Manual.
4
Installing the Wire Harness
Parts needed for this procedure:
2
Jumper wire (for use on traction units with serial number 3999999999 and below only)
1
Fit-up kit electrical harness
1
Electrical harness cap
4
Cable tie
Procedure
Note:
Use the jumper wires on traction units with serial number 3999999999 and below only.
1.
Plug the fit-up kit harness connector into the backhoe electrical harness connector
Note:
When you are not using the backhoe, ensure to install the electrical harness cap on the backhoe
end of the fit-up kit harness.
2.
Route the fit-up kit electrical harness alongside the hydraulic hoses as shown in
3.
Route the harness through the hydraulic hose access hole into the underside of the control panel
(Figure
5).
Note:
Use the hydraulic hose tie downs to secure the harness.
Figure 4
2. Tie-down link (2)
6
g352719
(Figure
5).
Figure
5.