Table of Contents
Advertisement
Figure 72
1. Port CR (EHI steering
valve)
2. Port R
3. Straight hydraulic fitting
(-6 x 18 mm)
Installing the EHI Steering Valve
1.
Align the holes in the body of the EHI steering
valve with the holes in the manifold mount
(Figure
73).
Figure 73
1. EHI steering valve
2. Manifold mount
2.
Secure the valve to the mount
flange-head capscrews (8 x 16 mm).
g299719
4. Port CL
5. Port L
g299722
3. Flange-head capscrew (8
x 16 mm)
(Figure
73) with 3
16
Drilling the Console Base
Parts needed for this procedure:
1
Grommet
Procedure
1.
Tilt the passenger seat forward to access the
console base
2.
Align a piece of sheet metal, approximately 120
mm (4 inches) wide, through the prop-rod slot
in the console base, between the base and the
wire harness below it.
Note:
The sheet metal protects the wire
harness when you drill through the console
base.
3.
Measure 69 mm (2-11/16 inches) rearward
from the square hole near the prop-rod slot in
the console base, and mark the console base
(Figure
75).
32
(Figure
74).
Figure 74
g299797
Advertisement
Table of Contents
