Table of Contents
Advertisement
25
Installing the Heat Shield
and Undercarriage Shroud
2015 and Later Machines
No Parts Required
Procedure
If removed, installed the heat shield and undercarriage
shroud to the bottom of the machine; refer to the
Operator's Manual for your machine.
26
Setting Up and Calibrating
the Software
No Parts Required
Calibrating the Compass
Ensure that the GeoLink compass is calibrated,
refer to the X25 GeoLink Operator's Manual for your
machine.
Preparing to Calibrate the Machine
Installer provided equipment: a USB/CAN interface
cable (Toro DIAG cable) Part No. 115-1944
1.
Park the machine on the grass at a level location.
2.
Shut off the engine and engage the parking
brake.
Connecting the Laptop Computer
to the Machine
1.
Plug the USB/CAN interface cable into a USB
port of the laptop computer.
2.
At the machine, rotate the key to the O
3.
Open the Danfoss Plus+1 service tool on your
laptop computer.
4.
Remove the cap from the 3-socket connector of
the kit wire harness CAN port labeled
DIAG CONNECTOR
N
DUPLICATE
, and plug the 3-pin connector
USB/CAN interface cable into the 3-socket
connector
1. 3-socket connector
(labeled
CONNECTOR
harness)
2. 3-pin connector
(USB/CAN interface
cable)
5.
On the dash panel of the machine, press
enable/transport switch to the E
position
1. T
RANSPORT
2. E
NABLE
position.
6.
On your laptop computer, click the
PVED-CLS_2.00_
7.
In the System Navigator tab, navigate the A
C
ALIBRATION
(Figure
60
(Figure
147).
Figure 147
3. Cap
DUPLICATE DIAG
—kit wire
(Figure
148).
Figure 148
M
position
3. Enable/transport switch
ODE
M
position
ODE
_D.P1D file.
REV
directory, and click the + icon
149).
g302258
M
NABLE
ODE
g303495
UTO
Advertisement
Table of Contents
