Table of Contents
Advertisement
7
Removing the Heat Shield
and Undercarriage Shroud
2015 and Later Machines
No Parts Required
Procedure
If equipped, remove the heat shield and shroud from
the bottom of the machine; refer to the Operator's
Manual for your machine.
8
Plugging the Hydraulic
Pump Suction Hose
Parts needed for this procedure:
1
Hose plug (plastic)
Procedure
Important:
When you remove the suction hose
from the hydraulic pump, you must quickly install
the hose plug to minimize hydraulic fluid loss.
1.
At the bottom of the machine, align a drain pan
under the hydraulic pump and place the hose
plug near the pump
Figure 25
1. Hose plug
(Figure
25).
2.
Loosen the hose clamp that secures the suction
hose to the hydraulic pump
1. Hose clamp
2. Suction hose
3.
Remove the suction hose from the barb fitting
of the pump and insert the hose plug into the
hose
(Figure
4.
Secure the plug to the hose with the hose clamp.
g313934
16
(Figure
26).
Figure 26
3. Hose plug
26).
g313935
Advertisement
Table of Contents
