Installing The Scsi Software For Windows Nt 4.0 - Epson GT-10000 User Manual

5. When you see a screen indicating that
Windows is ready to install the best
driver for this device, click
begin driver installation.
6. If your system stops installation and
requests files from your Windows
operating system CD-ROM, replace
your scanner software CD-ROM with
your Windows disk and click
continue. You may be prompted to
re-insert the EPSON disk after the
Windows disk.
7. When you see a screen indicating that installation is complete, click
Add New Hardware Wizard closes, and you return to the Windows desktop.
8. To verify that the SCSI board was detected, click
, then double-click the
Panel
necessary. You should see
list. You should see
the dialog box.
9. When you're finished, restart your computer.
If you're running Windows 98, continue with the instructions on page 19 to install
your scanner software. If you're running Windows 95, continue with the instructions
on page 24.

Installing the SCSI Software for Windows NT 4.0

Depending on how your computer system was originally set up, the SCSI driver may
be installed automatically when you start your computer. If not, follow the steps
below. You may be asked to insert your Windows operating system CD-ROM during
software installation. Please have your Windows CD-ROM handy, in case it is
needed.
16
Setting Up Your Scanner
to
Next
to
OK
icon. Click the
System
SCSI controllers
Adaptec AIC-78XX PCI SCSI
,
Start Settings
Device Manager
in the list. Click the
in the list. Click
The
Finish.
,
Control
tab, if
to expand the
+
to close
OK