Epson GT-10000 User Manual page 93

Check for conflicts in your
SCSI ID number setting, I/O
address, the interrupt setting for
your SCSI board, and other
settings. For information about
the SCSI ID setting, see
page 11. For information about
choosing other settings, see your
computer manual.
Check your image source setting
in the Select Source window.
Make sure you selected
.
TWAIN Pro
If you also installed EPSON
Scan Server on your computer,
make sure it's not running.
If you don't see
EPSON
or
TWAIN Pro EPSON
TWAIN Pro Network
Select Source window, uninstall
your software, then reinstall it.
See the instructions for
uninstalling software on
page 93.
If you have another EPSON
scanner and have a previous
version of EPSON TWAIN
installed, uninstall the older
version. See the instructions for
uninstalling software on
page 93.
You can't start EPSON TWAIN
Pro Network from a client
computer
EPSON
in the
Make sure the scanner and the
scanner server are both turned
on.
Make sure the cables connecting
the scanner, the scanner server,
and the client computer meet
the system requirements and
are properly connected. See
page 116.
Make sure the correct IP address
for the scanner server is entered
in the EPSON TWAIN Pro
Network window for the client
computer.
Make sure the network interface
card is installed correctly in
both the scanner server and the
client computer.
Make sure both the scanner
server and client computer are
running the TCP/IP protocol.
If more than one scanner is
connected to the scanner server,
make sure the EPSON
GT-10000 is selected as the
default scanner.
Solving Problems
87