Epson GT-10000 User Manual page 75

6. If you're not installing EPSON TWAIN
Pro, go to step 9.
If you're installing EPSON TWAIN Pro,
follow the instructions on the screen.
When you see the window on the right,
make sure
SCSI
selected under Scanner Selection.
If you're installing EPSON TWAIN Pro Network in order to use
a scanner attached to another computer, you'll see a window
that asks for the Network Scanner Address (the scanner
server's IP address). Enter the IP address for the scanner
server you want to connect to. See page 73 for instructions.
Then continue with step 7 below.
7. Click to check scanner operation. If the scanner is communicating with your
Test
computer, you see
to close the window.
8. When you see the EPSON Screen
Calibration Utility, move the slider right or
left until the stripes match as closely as
possible. Then click
(The EPSON Screen Calibration Utility
calibrates the preview image you see in
your EPSON TWAIN Pro driver to match
your monitor settings.)
and are
GT-10000
Status: Device Reader
.
OK
under Scanner Information. Click
OK
Network Scanning
69