Testing Your Scanner Connection; Installing The Software For Windows Nt 4.0 - Epson GT-10000+ User Manual

Test your connection as described in the following section. If you want to install
PhotoDeluxe, see page 45.

Testing Your Scanner Connection

You need to verify that your scanner was properly connected and the software was
installed correctly. Follow these steps to test scanner operation:
1. Double-click the
Panel to open the Scanners and Cameras folder.
2. Double-click the
3. If necessary, click the
the
Test Scanner or Camera
the scanner is operating properly,
appears next to Status.
Ready
4. Click
OK
window.

Installing the Software for Windows NT 4.0

Follow the instructions in this section to install the EPSON GT-10000+ scanner
driver and other software on your scanner software CD-ROM.
If you want to use your scanner on a network, go to Chapter 6, "Network
Scanning," instead.
1. Make sure your SCSI board and SCSI driver are installed and the scanner is
connected to your computer (as described in Chapter 1).
42
Installing Scanner Software
Scanners and Cameras
EPSON GT-10000
General
to close the scanner's properties
icon in the Windows Control
icon.
tab. Click
button. If
Device