Installing The Scanner Server Software For Windows 98 - Epson GT-10000 User Manual

Follow the instructions for your operating system:
If you're running Windows 98, continue with the next section, "Installing the
Scanner Server Software for Windows 98."
If you're running Windows 95, go to "Installing the Scanner Server Software for
Windows 95" on page 63.
If you're running Windows NT 4.0, go to "Installing the Scanner Server Software
for Windows NT 4.0" on page 67.
To install software on the client computers, see "Setting Up Client Computers" on
page 72 instead.
Installing the Scanner Server Software for
Windows 98
Follow the instructions in this section to install your EPSON GT-10000 scanner
driver and other software on your scanner software CD-ROM. Before you begin,
make sure you recalibrate your monitor to factory specifications. (See your
manufacturer's documentation for instructions.)
Installing the Scanner Driver on Windows 98
You may be asked to insert your Windows CD-ROM during this procedure.
Make sure you have your Windows CD-ROM available, or know where to find the
Windows source files on your hard drive. If you need help locating your source files,
contact your computer manufacturer.
1. Make sure your SCSI board and SCSI driver are installed and the scanner is
connected to your computer.
2. Turn on the scanner first, then
turn on your computer. When you see
the window on the right, click
(The Wizard may also say it has found
an unknown device.)
.
Next
Network Scanning
57