Installing The Scsi Interface Board - Epson GT-10000 User Manual

Installing the SCSI Interface Board

You must install your SCSI board before installing the scanner driver and software
applications. If you already have a SCSI board installed in your PC, skip this section.
1. Turn off the computer and any peripheral devices. Unplug any power cords; then
disconnect all cables from the back panel of your computer.
2. Remove the cover from your computer.
3. Remove the slot cover from an empty PCI
expansion slot in your computer. (Refer to
your computer documentation for information
about your PCI slots.)
4. Insert the SCSI interface board into the slot,
then secure it with the bracket screw.
5. Replace the computer cover and reconnect all
cables.
6. Continue with the following section,
"Unlocking the Scanner."
10
Setting Up Your Scanner
For additional installation information, see the documentation
for your SCSI board or computer.
Static electricity can damage electronic components. Ground
yourself before you touch any of the computer's internal
components by touching an unpainted metal surface inside
the computer case.