Table of Contents
Advertisement
Maintenance
Front windshield wiper blade
OON072076
To inspect or replace the windshield
wiper blades and to prevent damaging
the hood, move the windshield wiper
blades to the service position as follows;
僅 After turning off the engine, move the
wiper switch to the single wiping
(MIST) position within 20 seconds and
hold the switch more than 2 seconds
until the wiper blade is in the fully up
position
Replacing front windshield wiper
blade
Type A
1. Raise the wiper arm and turn the
wiper blade assembly to expose the
plastic locking clip.
OCV071052L
CAUTION
Wiper arms
僅 Do not allow the wiper arm to fall
against the windshield, since it may
chip or crack the windshield.
僅 Do not pull wiper arm forward, since
arm could chip hood paint.
2. Compress the clip and slide the blade
assembly downward.
OCV071053L
3. Lift it off the arm.
OON072078
4. Install the blade assembly in the
reverse order of removal.
Type B
1. Raise the wiper arm.
2. Lift up the wiper blade clip (1). Then
pull down the blade assembly and
remove it (2).
ONQ5041198_2
3. Install the new blade assembly.
ONQ5041199
4. Return the wiper arm on the wind-
shield.
5. Turn ignition to the ON position and
wiper arms will return to the normal
operating position.
Wiper blades
8
8
23
Advertisement
Chapters
Table of Contents
