Kia Telluride 2023 Owner's Manual page 122

Features of your vehicle
NOTICE
In cold and wet climates, power windows
may not work properly due to freezing
conditions.
The ENGINE START/STOP button must
be in the ON position for power windows
to operate.
Each door has a power window switch
that controls the door's window. The
driver has a power window lock switch
which can block the operation of rear
passenger windows. The power windows
can be operated for approximately 10
minutes after the ENGINE START/STOP
button has been placed in the ON posi-
tion. However, if the front doors are
opened, the power windows cannot be
operated even within the 10 minutes
period.
The driver's door has a master power
window switch that controls all the win-
dows in the vehicle.
If the window cannot be closed because
it is blocked by objects, remove the
objects and close the window.
NOTICE
While driving with the rear windows
down or with the sunroof (if equipped) in
an open (or partially open position), your
vehicle may demonstrate a wind buffet-
ing or pulsation noise. This noise is a
normal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one or
both of the rear windows down, partially
lower both front windows approximately
1 inch (2.5 cm). If you experience the
noise with the sunroof open, slightly
reduce the size of the sunroof opening.
4 42
CAUTION
Do not install any accessories in the
vehicle that extend into the open win-
dow area. Such objects will impact the
proper function of the Automatic rever-
sal "jam protection" feature.
NOTICE
If you press the one-touch window but-
ton for micro adjustment, the glass will
go down to a specific location to
improve your convenience.
Window opening and closing
You can open and close windows using
the power window switch.
Auto up/down window
ONQ5031015L
Pressing or pulling up the power window
switch momentarily to the second detent
position (2) completely lowers or raises
the window even when the switch is
released. To stop the window at the
desired position while the window is in
operation, pull up or press down and
release the switch (1).
If the power window does not operate
normally, the automatic power window
system must be reset as follows:
1. Place the ENGINE START/STOP but-
ton to the ON position.
2. Close the window and continue pull-
ing up the power window switch for at
least 1 second after the window is
completely closed.
Windows