Kia Telluride 2023 Owner's Manual page 45

Safety features of your vehicle
僅 If the rear door is opened or closed
under 10 km/h, warning light and
warning sound does not work even if
driving over 20 km/h.
Seat belt - Driver's 3-point system
with emergency locking retractor
The following explains how to fasten and
adjust the driver's seat belt.
Fastening the your seat belt:
ONQ5021104N
僅 Pull it out of the retractor and insert
the metal tab (1) into the buckle (2).
There will be an audible "click" when
the tab locks into the buckle.
OCV031076
WARNING
You should place the lap belt portion as
low as possible and snugly across your
hips. If the lap belt is located too high on
your waist, it may increase the chance of
injury in the event of a collision.
The arm closest to the seat belt buckle
should be over the belt while the other
arm should be under the belt as shown
in the illustration. Never wear the seat
belt under the arm closest to the door.
The seat belt automatically adjusts to
the proper length only after the lap belt
portion is adjusted manually so that it
fits snugly around your hips. If you lean
forward in a slow, easy motion, the belt
will extend and let you move around. If
there is a sudden stop or impact, how-
ever, the belt will lock into position. It will
also lock if you try to lean forward too
quickly.
NOTICE
If you are not able to pull out the seat
belt from the retractor, firmly pull the
belt out and release it. Then you will be
able to pull the belt out smoothly.
Adjusting the height of shoulder
belt
You can adjust the height of the shoul-
der belt anchor to one of the 4 positions
for maximum comfort and safety.
ONQ5021018
The height of the adjusting seat belt
should not be too close to your neck.
The shoulder portion should be adjusted
so that it lies across your chest and mid-
way over your shoulder near the door
and not your neck.
To adjust the height of the seat belt
anchor, lower or raise the height
adjuster into an appropriate position.
僅 To raise the height adjuster, pull it up
(1).
僅 To lower it, push it down (3) while
pressing the height adjuster button
(2).
Release the button to lock the anchor
into position. Try sliding the height
Seat
3
3 23