Kia Telluride 2023 Owner's Manual page 379

Driver assistance system
Driving speed limit
ONQ5EP041184L
A: Driver's grasp not detected. Speed
will be limited
When Highway Driving Assist is can-
celed by the hands-off warning, The
driving speed will be limited.
While Driving Speed Limit function is
operating, the warning message will
appear on the cluster, and an audible
warning will sound continuously.
Driving to one side within lane (if
equipped)
OON052308
When vehicle speed is above 40 mph
(60 km/h), if a vehicle around you is
driving at a close distance, your vehicle
will control steering in the opposite
direction of the vehicle to assist in safe
driving. If there are vehicles in both sides
of the lane that are driving close to you,
the function will not veer to the opposite
side of the lane.
Highway Driving Assist standby
When the Smart Cruise Control is tem-
porarily canceled while Highway Driving
Assist is operating, Highway Driving
Assist will be in the standby state. At this
time, Lane Following Assist will operate
properly.
Highway Driving Assist (HDA)
NOTICE
僅 Driving Speed Limit helps you drive
below 40 mph (60 km/h). At this time,
the vehicle decelerates due to the
vehicle ahead. After the vehicle has
decelerated, it cannot automatically
accelerate.
僅 Driving Speed Limit will cancel in the
following circumstances:
- When the driver grabs the steering
wheel again
- When the driver turns on Lane Fol-
lowing Assist by pressing the Lane
Driving Assist button
- When (+), (-), ( ) switch or ( ) but-
ton is operated, or the accelerator
pedal or the brake pedal is
depressed
Highway Lane Change Assist (if
equipped)
Display and control
You can see the status of the Highway
Lane Change Assist function operation
in the Driving Assist view on the cluster.
Refer to "LCD Display Modes" on page 4-
76.
Highway Lane Change Assist function
will be displayed as below depending on
the status of the function.
Ready/Operating
OON052266
6
6 83