Kia Telluride 2023 Owner's Manual page 148

Features of your vehicle
contact HomeLink customer service at 1-
800-355-3515.
2. Press and hold the button on the
HomeLink system you wish to train
and the button on the transmitter
while the transmitter is approximately
1~3 inches (2~8 cm) away from the
mirror. Do not release the buttons
until step 3 has been completed.
OON042506
1) Flashing
2) Transmitter
3. The HomeLink indicator light will
flash, first slowly and then rapidly.
When the indicator light flashes rap-
idly, both buttons may be released.
(The rapid flashing light indicates suc-
cessful programming of the new fre-
quency signal.)
NOTICE
Some gate and garage door openers
may require you to replace step 3 with
the "cycling" procedure noted in the
"Canadian Programming" section of this
document.
Programming rolling code
To train a garage door opener (or other
rolling code equipped devices) with the
rolling code feature, follow these instruc-
tions after completing "Programming
HomeLink" on page 4-67. (A second per-
son assisting may make the following
training procedures quicker & easier.)
4. Locate the "learn" or "smart" button on
the device's motor head unit. Exact
4 68
location and color of the button may
vary by product brand. If there is diffi-
culty locating the "learn" or "smart"
button, reference the device's owner's
manual or contact HomeLink at 1-
800- 355-3515 or on the internet at
www.homelink.com.
5. Press and release the "learn" or
"smart" button on the device's motor
head unit. You have 30 seconds to
complete step 6.
6. Return to the vehicle and firmly press
and release the programmed Home-
Link button up to three times. The roll-
ing code equipped device should now
recognize the HomeLink signal and
activate when the HomeLink button is
pressed. The remaining two buttons
may now be programmed if they have
not already been programmed. Refer
to "Programming HomeLink" on page
4-67.
Operating HomeLink
To operate, simply press the pro-
grammed HomeLink button.
Activation will now occur for the trained
product (garage door, security system,
entry door lock, estate gate, or home or
office lighting). For convenience, the
hand-held transmitter of the device may
also be used at any time. The HomeLink
Wireless Controls system (once pro-
grammed) or the original hand-held
transmitter may be used to activate the
device (e.g., garage door, entry door
lock, etc.). In the event that there are still
programming difficulties, contact Home-
Link at 1-800-355-3515 or on the inter-
net at www.homelink.com.
Mirrors