Kia Telluride 2023 Owner's Manual page 256

Driving your vehicle
place without applying the EPB. And
use wheel chocks.
僅 Do not drive your vehicle with the EPB
applied. It may cause excessive wear
of brake pad and brake rotor.
僅 A click sound may be heard while
operating or releasing the EPB, but
these conditions are normal and indi-
cate that the EPB is functioning prop-
erly.
僅 When leaving your keys with a park-
ing lot attendant or valet, make sure
to inform him/her how to operate the
EPB.
僅 When the battery is drained, the EPB
does not apply or release. In this case,
jump start your vehicle.
Malfunction of EPB
ONQ5H041017
If the EPB malfunction indicator remains
on, it indicates that the EPB may have
malfunctioned. If this occurs, have the
system checked by an authorized Kia
dealer.
The EPB malfunction indicator may
appear when the ESC indicator comes
on to indicate that the ESC is not work-
ing properly, but it does not indicate a
malfunction of the EPB.
CAUTION
僅 The EPB warning light may appear if
the EPB switch operates abnormally.
Shut the engine off and turn it on
again after a few minutes. The warn-
ing light will go off and the EPB switch
5 24
will operate normally. However, if the
EPB warning light is still on, have the
system checked by an authorized Kia
dealer.
僅 If the parking brake warning light
does not appear or blinks even
though the EPB switch was pulled up,
the EPB is not applied. If the parking
brake warning light blinks when the
EPB warning light is on, press the
switch, then pull it up. Once more
press it back to its original position
and pull it back up. If the EPB warning
does not go off, have the system
checked by an authorized Kia dealer.
AUTO HOLD
The Auto Hold is designed to maintain
the vehicle in a standstill even though
the brake pedal is not pressed after the
driver brings the vehicle to a complete
stop by pressing the brake pedal.
Applying Auto Hold function
1. Press the brake pedal and start the
vehicle.
2. Press the Auto Hold button. The white
AUTO HOLD indicator will come on
indicating the system is in standby.
OON052015
Before the Auto Hold will engage, the
driver's door and engine hood must
be closed and the liftgate must be
closed.
When coming to a complete stop by
pressing the brake pedal, the AUTO
HOLD indicator changes from white to
green indicating the AUTO HOLD is
Brake system