Using Via Raid Bios Setup To Change Array Mode - SOLTEK SL-KT880E-GR Manual

SL-KT880E-GR/RL/R

5-4 Using VIA RAID BIOS Setup to change Array mode

(5-4-1) If you wants to change the RAID mode, say, from RAID 0 to
RAID 1, you must return to the Initial RAID BIOS Setup screen. Then,
press the "Arrow" key to mark the "Delete Array" bar and press <Enter>.
VIA Tech. VT8237 SATA RAID BIOS Ver 2.10
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel
Channel0 Master
Channel0 Slave
Channel1 Master
Channel1 Slave
(5-4-2) Instantly, the Bootable Hard Disk(s) is marked up for deletion.
Press <Enter> key on this screen to delete the set-up array.
VIA Tech. VT8237 SATA RAID BIOS Ver 2.10
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel
[ ] Channel0 Master
Channel0 Slave
[ ]Channel1 Master
Channel1 Slave
Delete a RAID array contain the
hard disks attatched to VIA RAID
controller
F1
Enter : Confirm the selection
ESC : Exit
Drive Name Array Name
ST380023AS ARRAY 0
No Drive
ARRAY 0
ST380023AS
No Drive
Delete a RAID array contain the
hard disks attatched to VIA RAID
controller
F1
Enter : Confirm the selection
ESC : Exit
Drive Name Array Name
ARRAY 0
ST380023AS
No Drive
ARRAY 0
ST380023AS
No Drive
90
: View Array/disk Status
: Move to next item
Mode Size(GB)
ATA 133 74.53
ATA 133 74.53
: View Array/disk Status
: Move to next item
Mode Size(GB)
ATA 133 74.53
ATA 133 74.53
Status
Boot
Boot
Status
Boot
Boot