Roll Paper Cut For Borderless Printing - Epson Stylus Pro 7700 User Manual

Epson Stylus Pro 7700/7710/9700/9710

Roll paper cut for borderless printing

When you use roll paper for borderless printing, the paper cut operation is different according to the Borderless
and Auto Cut settings of the printer driver.
No margins for left and right
Printer driver Borderless: Enable
setting
Auto Cut: Normal Cut
Printer
operations
Explanation Normal Cut is default setting.
Note:
When you want to cut prints manually, select Off.
User's Guide
Variety of Printings
No margins for all directions
(single cut)
Borderless: Enable
Auto Cut: Single Cut
❏
The top area may smear
because the top area of the
roll paper is cut while the
print operation is stopped.
❏
If the cut position is slightly
shifted, the image on the
continuous page remains on
the top or bottom area;
however, the printing time
gets shorter.
❏
If you select Single Cut and
print only a piece of paper,
the operation will be the
same as Double Cut. If you
print more than one paper
continuously, cut 1 mm along
the inside of each picture to
avoid creating a margin
between pictures.
133
No margins for all directions
(double cut)
Borderless: Enable
Auto Cut: Double Cut
❏
The top area may smear
because the top area of the
roll paper is cut while the
print operation is stopped.
❏
Because the inside of each
picture is cut in order to not
leave a white area in the top
and bottom areas, the
length of the paper
becomes 2 mm shorter.
❏
After cutting the bottom
area of the previous page,
the printer feeds the paper
and then cuts the top area
of the next page. Because of
that, about 60 to 127 mm of
scrap of paper is produced.
Take care to cut the paper
precisely.