Epson Stylus Pro 7900/7910/9900/9910
Roll paper cut for borderless printing
When you use roll paper for borderless printing, the paper cut operation is different according to the Borderless and
Auto Cut settings of the printer driver.
No margins for left and right
Printer driver
Borderless: Enable
setting
Auto Cut: Normal Cut
Printer
operations
Explanation
Normal Cut is default setting.
Note:
When you want to cut prints manually, select Off.
User's Guide
No margins for all directions
(single cut)
Borderless: Enable
Auto Cut: Single Cut
The top area may smear
O
because the top area of the
roll paper is cut while the print
operation is stopped.
If the cut position is slightly
O
shifted, the image on the
continuous page remains on
the top or bottom area;
however, the printing time
gets shorter.
If you select Single Cut and
O
print only a piece of paper,
the operation will be the same
as Double Cut. If you print
more than one paper
continuously, cut 1 mm along
the inside of each picture to
avoid creating a margin
between pictures.
No margins for all directions
(double cut)
Borderless: Enable
Auto Cut: Double Cut
The top area may smear
O
because the top area of the
roll paper is cut while the
print operation is stopped.
Because the inside of each
O
picture is cut in order to not
leave a white area in the top
and bottom areas, the length
of the paper becomes 2 mm
shorter.
After cutting the bottom
O
area of the previous page,
the printer feeds the paper
and then cuts the top area of
the next page. Because of
that, 80 to 130 mm of scrap
of paper is produced. Take
care to cut the paper
precisely.
Variety of Printings
141