Epson Stylus Pro 7700 User Manual page 46

Epson Stylus Pro 7700/7710/9700/9710
G
Tape the leading edge of the roll paper to the
take-up reel core in three places.
H
Press the button to feed the paper forward
and create a loop of slack.
I
Set the Manual switch to Forward and hold it
for a while to take up the roll paper for three or
more revolutions of the take-up paper core.
After taking up the paper, ensure that there is
adequate slack between the roll paper and the
take-up reel core.
Note:
Place the Tensioner in the slack of the center of
the roll paper. See the following section for the
paper which uses the tensioner.
See "Paper Information" on page 166
User's Guide
Paper Handling
Winding paper backward
A
Turn on the printer, and then pull out the roll
paper. See step 3 to 6 of the following section.
B
Pull the bottom of the roll paper around the
back of the reel core as shown below. Then tape
the leading edge of the paper to the reel core in
three places.
C
Press the
and create a loop of slack.
D
Set the Manual switch to Backward and hold it
for a while to take up the roll paper for three or
more revolutions of the take-up paper core.
After taking up the paper, ensure that there is
adequate slack between the roll paper and the
take-up reel core.
46
"Winding paper forward" on page 45
button to feed the paper forward