Sos Settings; System Update - Grandstream Networks GSC3570 User Manual

Format: Touch "Format" to perform SD card initialization and mount.
Uninstall: Uninstall the SD card.
Notes
The maximum SD/TF card supported is 256G.
The SD card must be formatted by GSC3570 before usage.

SOS Settings

Select the Call Mode and configured from which account to make calls when SOS key is pressed as well as the receiving
numbers.
Call Mode: Select between Serial or Parallel Hunting.
Number 1-4: Set the Account from which the outgoing call will be made and towards which Number.
Syslog
This page allows to initiate upgrade process by checking if a new firmware is available in the configured firmware
server path, and then upgrading if available. Users can press Settings to configure Firmware/Provisioning settings directly
from the phone's LCD. Following settings can be configured from this screen:
Syslog level: Select the level of logging for syslog. The default setting is "None". There are 4 levels: DEBUG, INFO,
WARNING and ERROR.
System log protocol: Select the protocol of syslog (UDP or SSL/TLS).
Syslog server address: The URL/IP address for the syslog server. If the GSC3570 has network connection, the phone will
send the syslog packets to this server address.
System log keyword filtering: Only send the syslog with keyword, multiple keywords are separated by comma. Example:
set the filter keyword to "SIP" to filter SIP log.

System Update

Configure the Firmware server path and protocol. Click on Update Now button to start immediate upgrade.
Click on to access the Upgrade and Provisioning configuration:
Firmware Upgrade and Provisioning:
Always Check for New Firmware:
Always Check at bootup when F/W pre/suffix changes
Skip the Firmware Check.
Firmware Upgrade via: Set the protocol to either HTTP/HTTPS or TFTP for the Firmware server.
Firmware Server Username: Configures the username for the Firmware HTTP/HTTPS server.
Firmware Server Password: Configures the password for the Firmware HTTP/HTTPS server.
Firmware Server Path: Configure the Firmware server path.
Config Upgrade via: Set the protocol to either HTTP/HTTPS or TFTP for the Config server.
Config Server Username: Configures the username for the Config HTTP/HTTPS server.
Config Server Password: Configures the password for the Config HTTP/HTTPS server.
Config Server Path: Configure the Config server path.
Reset