Grandstream Networks GSC3570 User Manual page 7

1. Ensure your device is powered up and connected to the Internet.
2. Slide to the second home page and press "Setting"
3. Select "Network Status" to check the IP address.
4. Type the unit's IP address in your PC browser. (See figure below).
5. Enter admin's username and password to access the configuration menu.
Note
The factory default username is "admin" while the default random password can be found on the sticker at the back of the unit
To setup your GSC3570 from the LCD, please follow the steps below:
1. Make sure the device is idle.
2. Slide to the second home page and press "Setting". Browse the GSC3570 MENU for Status, Network information, Features
and Basic/Advanced Settings...
3. Press "Home" Button to go back to idle screen.
Alarm IN/OUT
rd
Alarm_In could use any 3 party Sensors (like IR Motion Sensor).
Alarm_Out device could use 3 party Siren and Strobe Light, or Electric Door Striker, etc.
The figure below shows illustration of the Circuit for Alarm_In and Alarm_Out.
Figure 6: GSC3570 web interface
rd
Figure 7: Alarm_In/Out Circuit for GDS3710