Network Status; Storage Info; Ethernet Settings - Grandstream Networks GSC3570 User Manual

Hd intercom & facility control station

Hide thumbs Also See for GSC3570:

Table of Contents

Status

Account Status

This page displays all available accounts on the phone with respective status (Configured/Not Configured and

Registered/Unregistered).

Network Status

This page displays Network status including Ipv4/v6 address, subnet mask, gateway, DNS server...

System Info

This page shows system info including Hardware version, P/N, U-boot version, Kernel version, System version, Certificate

version, System up time.

This page shows the SD Card storage info.

Network

Users can configure Ethernet settings and Wi-Fi settings here.

Ipv4 Settings: Here user can configure the Ipv4 address type for both data and VoIP calls. For network configuration of

data, if DHCP is selected, the phone will get an IP address automatically from the DHCP server in the network. This is the

default mode. If Static IP is selected, manually enter the information for IP Address, Subnet Mask, Default Gateway, DNS

Server, and Alternative DNS server.

802.1x mode: This option allows the user to enable/disable 802.1x mode on the phone. The default setting is disabled. To

enable 802.1x mode, select the 802.1x mode and enter the required configuration depending on the 802.1x mode chosen.

The available modes are EAP-MD5, EAP-TLS and EAP-PEAP

Figure 51: GSC3570 System Settings

Table of Contents