Bowers & Wilkins TECHNICAL SUPPORT
Figure: 42
Once the 6" Cabinet Tube has been replaced (in reverse order) and following the instruction
in section 15 refit the Bass Unit Speaker in reverse order.
18. Lower 6" Cabinet Tube Removal
Start by removing the 8 x Hex Bolts shown in Figure: 43 and put these to one side for
reassembly.
Figure: 43
MF Cabinet Tube
The contents of this document and associated files contain confidential information that is propriety to Bowers & Wilkins, and
are intended solely for the purpose of servicing the product. The information is intended for use by service technicians familiar
with electronic products. No part of the contents should be supplied or published elsewhere.
Page 34 of 51
Acoustic Foam
Gasket
8 x Hex Bolts
Note: Aline the Gasket
before refitting the
Cabinet Tube.
Make sure that the
Acoustic Foam is still in
place, if not push it back
in place.
Note: Take care not to
drop any of the 8 x Hex
Bolts into the Cabinet or
scratch the Cabinet
Tube.
© Bowers & Wilkins 2016