Bowers & Wilkins 804 D3 Technical Manual page 23

Hide thumbs Also See for 804 D3:

Table of Contents

Bowers & Wilkins TECHNICAL SUPPORT

Figure: 20

Molex Plug

Rotate Shaft

Once the 2 x HF Cables have been removed from the Molex Plug carefully thread both of

the HF Cables into the HF Retaining Bolt Tool as shown in Figure: 21.

Now slide the Removal Bolt Tool up to the Retaining Bolt and proceed to unscrew the

Retaining Bolt. Once the Retaining Bolt is completely unscrewed slide the Removal Bolt Tool

back down the HF cables. This will allow the Retaining Nut and washer to slide down to the

Molex Crimp Pins as shown in Figure: 22.

Figure: 22

HF Retaining Bolt

HF Foam Gasket

HF Washer

HF Retaining Nut

HF Molex Crimp Pins

The contents of this document and associated files contain confidential information that is propriety to Bowers & Wilkins, and

are intended solely for the purpose of servicing the product. The information is intended for use by service technicians familiar

with electronic products. No part of the contents should be supplied or published elsewhere.

Page 23 of 51

Figure: 21

Note:

The Molex Tool may need the shaft

rotating to help travel the full distance on the

Crimp (take hold of the shaft).

HF Cables

HF Retaining

Bolt Tool

Table of Contents

Show Quick Links

Table of Contents