Hf Crossover Assembly Removal - Bowers & Wilkins 804 D3 Technical Manual

Bowers & Wilkins TECHNICAL SUPPORT

20. HF Crossover Assembly Removal

Start by removing the Mid – Range Speaker as in section 12, then remove the
Wadding shown in Figure: 50.
Figure: 50
Wadding
With the Wadding removed the Molex Connector is visible, pull the Molex Plug out of
the Molex Connector (these Red & Black Cables are for the Tweeter) and cut the Ty-
rap which holds the cable in place as shown in Figure: 51.
Figure: 51
Tweeter Cable
Speaker Cable
The Mid – Range Speaker Cable and Tweeter Cable will need to be fed through the
Internal Cabinet and their Rubber Bungs will need pushing down through the holes as
shown in Figure: 51.
Now follow section 15 and remove the Upper Bass Unit Speaker.
The contents of this document and associated files contain confidential information that is propriety to Bowers & Wilkins, and
are intended solely for the purpose of servicing the product. The information is intended for use by service technicians familiar
with electronic products. No part of the contents should be supplied or published elsewhere.
Page 38 of 51
Cut Ty - Rap
Molex Connector
Molex Plug
Ty – Rap cut
© Bowers & Wilkins 2016
Molex Connector
Molex Plug