Table of Contents
Advertisement
Bowers & Wilkins TECHNICAL SUPPORT
With the Upper Bass Unit Speaker removed unscrew the 4 x Phillips Screws holding
the HF Crossover Assembly in place as shown in Figure: 52.
Figure: 52
4 x Screws
HF Crossover Assembly
Take extra care when removing the 4 x Phillips Screws not to drop them into the
Cabinet. Now the HF Crossover Assembly can be removed at an angle as shown in
Figure: 53.
Figure: 53
The HF Crossover Assembly can now be replaced in reverse order, see Figure: 54 to
view the complete Upper Crossover Assembly.
The contents of this document and associated files contain confidential information that is propriety to Bowers & Wilkins, and
are intended solely for the purpose of servicing the product. The information is intended for use by service technicians familiar
with electronic products. No part of the contents should be supplied or published elsewhere.
Page 39 of 51
The Mid – Range Speaker
Cable and the Tweeter Cable
are both connected to the HF
Crossover Assembly.
These are both shown below
with their Rubber Bungs
Rubber Bungs
HF Crossover Assembly
© Bowers & Wilkins 2016
Hide quick links:
Advertisement
Table of Contents
