Draw Bar Assembly Removal - Bowers & Wilkins 804 D3 Technical Manual

Bowers & Wilkins TECHNICAL SUPPORT
Figure: 29
Mid - Range Crimp
Connectors
Disconnect the 2 x Crimp Connectors and then fit the replacement Mid - Range Speaker in
reverse order...

14. Draw Bar Assembly Removal

With the Mid – Range Speaker removed as per section 10, lift out the wadding and remove
the Sleeve Spring Stop, the Spring and 2 x Washers shown in Figure: 30.
Figure: 30
The contents of this document and associated files contain confidential information that is propriety to Bowers & Wilkins, and
are intended solely for the purpose of servicing the product. The information is intended for use by service technicians familiar
with electronic products. No part of the contents should be supplied or published elsewhere.
Page 28 of 51
Mid - Range Speaker
Sleeve Spring Stop
Sleeve Spring Stop
1 x Spring
2 x Washers
Wires
Brown & Blue
Draw Bar Assembly
1 x Spring
2 x Washers
© Bowers & Wilkins 2016
2 x Hex Bolts