Lf Crossover Assembly Removal - Bowers & Wilkins 804 D3 Technical Manual

Bowers & Wilkins TECHNICAL SUPPORT
Figure: 54

21. LF Crossover Assembly Removal

Start by removing the Upper and Lower Bass Unit Speakers as in section 15. Then
remove the 4 x Phillips Screws holding the LF Crossover Assembly in place shown in
Figure: 55.
Figure: 55
4 x Phillips Screws
Take extra care when removing the 4 x Phillips Screws not to drop them into the
Cabinet.
The LF Crossover Assembly can be removed at an angle as shown in Figure: 56.
The contents of this document and associated files contain confidential information that is propriety to Bowers & Wilkins, and
are intended solely for the purpose of servicing the product. The information is intended for use by service technicians familiar
with electronic products. No part of the contents should be supplied or published elsewhere.
Page 40 of 51
LF Crossover Assembly
HF Crossover Assembly
© Bowers & Wilkins 2016