Editing & Writing Programs / Compare - Novation Super Bass Station Owner's Manual

Editing a Program
About Editing/
Writing/Compare
To change or "Edit" a program, simply adjust the parameters you wish to alter. The Edit LED on
the display will flash to show that you are no longer listening to the stored program. If you do not
store this new edit before calling up another program it will be lost.
Writing a Program into Memory
The program memory on the Super Bass Station is divided up as follows: You cannot store programs in the ROM area ("A"
Bank 000 - 049) only in the RAM area.( "A" Bank 050 - 099 and "B" Bank 100 - 199) If you edit a factory program, you can
save it in one of the 150 user program locations. To store a new or edited program, move the "Write" switch to the "Enable"
position and the "Enable LED" flashes. Now, using the "Data Entry" buttons ( "0" to "9" only ) select the program number
where you want to store the program. Remember this is a three digit entry, "050" to "199" ( "000" to "049" are ROM ) To
store the program in the same location simply press the "WRITE" button. If you want to listen to a program before overwrit-
ing it use the Compare function.
Using the Compare Function
When you have edited a program, move the "Write" switch to the "Enable" position and the "Enable LED" flashes. Press the
"COMPARE" button once and the "Edit" LED will flash at a faster rate to indicate "Compare" mode is active. You can now
listen to the original program before deciding whether you want to overwrite it or not. Check the program using an external
keyboard / computer or the "Audition" button on the front panel. Pressing the "COMPARE" button again will bring back the
edited program. If you do want to save the program in this location, press the "WRITE" button and the "Write" LED on dis-
play panel flashes momentarily. If you don"t want to save the program in this location you can choose another by simply
10