Novation Super Bass Station Owner's Manual page 9

To use the Super Bass Station's CV and Gate outputs with older analogue equipment estab-
lish which type of interface your vintage equipment has. There are several differing types of
CV and Gate and so you should check in the vintage equipments owners manuals for
details of what standard your equipment is. If this is not available, set as shown in the table
below. This covers most types of CV and Gate variations however there are sometimes slight variation between different
models made by the same manufacturer. You will have to set the MIDI Channel you want the analogue equipment to
respond to and the "type" of CV Gate should also be specified. To do this refer to page 54 "CV / Gate Channel" and page
55 "CV / Gate Type" for details.
Ident for CV / Gate type parameter
"00" =
"01" =
"02" =
"03" =
"04" =
"05" =
The Super Bass Station can also have it's Arpeggiator Latch parameter switched on and off via MIDI. To do so connect a
sustain pedal to the master keyboard. The Super Bass Station reads sustain information as Arpeggiator latch "on" / "off" so
depressing the sustain pedal will switch the Arpeggiator latch "on" and releasing the sustain pedal will switch Arpeggiator
latch "off". For this to work properly the master keyboard should be transmitting on the same MIDI channel as the RX chan-
nel of the Super Bass Station. Additionally this parameter may work in the reverse manner as described if the incorrect
footswitch is connected to the master keyboard. Some master keyboards have the ability to reverse this, refer to the master
keyboards owners manual for details.
Manufacturer CV Type
Ronald / Arp / Sequential Volts Per Octave
Yamaha / Korg Hertz Per Octave
Moog Volts Per Octave
Ronald / Arp / Sequential Volts Per Octave
Yamaha / Korg Hertz Per Octave
Moog Volts Per Octave
Applications
Advanced
Gate Type Range
+Gate Pulse C0 to C5
- S/Trig C-1 to C5
+S/Trig C0 to C5
+Gate Pulse C-1 to C4
- S/Trig C-2 to C4
+S/Trig C-1 to C4
7