Button 8 Cv / Gate Channel - Novation Super Bass Station Owner's Manual

Data Entry/Program
Utilities/CV/Gate
Related groups of parameters are in "Pages" within each button. This button is used to
access the CV / Gate Interfaces parameters.
Pages exist within this button and they are selected by pressing button 8 again. Refer to the Ident Map on the outside back
cover of this manual for more details. To change the value of any parameter use the "Data Entry / Portamento" Rotary con-
trol. Fine increments of parameters values can be set using the "-" and the "+" Buttons.
Page 1 - CV / Gate MIDI Channel
This display will alternate between "CH" ident ( CV / Gate MIDI Channel ) and it's value. Use the Data Entry / Portamento
Rotary control to adjust the value of this parameter. This parameter controls which MIDI channel the MIDI to CV / Gate out-
puts will respond to. The range is "oF" and "01" to "16". In the "oF" position there is no output from the CV / Gate outputs. in
the "01" position any MIDI notes received on MIDI Channel 1 will be converted as sent from the CV /Gate outputs.
NOTE: This must be a monophonic line. CV / Gate interfaces are not polyphonic.
This parameter is memorised as Global.
54
Button 8 - CV / Gate Ch
8
CV / GATE CH
PROGRAM
MIDI RX CH
MIDI TX CH
UTILITY
EDIT WRITE SAVE
Ident
PROGRAM
MIDI RX CH
MIDI TX CH
UTILITY
EDIT WRITE SAVE
Value