Factory & Restoring Factory Programs - Novation Super Bass Station Owner's Manual

entering any program number from "050" to "099" in the "A" Bank and "100" to "199" in the
About Compare/
"B" Bank using the "Data Entry" keypad buttons "0" to "9".
Factory Programs
NOTE: In this mode the "-" and "+" Buttons cannot be used.
Once again, you can check the programs using the "COMPARE" feature and then, when you have found a suitable loca-
tion, press the "WRITE" button. The program is now saved.
Note 1: Always return the "WRITE" switch to the "Protect" position after completing a save operation. This will avoid any
accidental erasure of programs. The "Write" LED will flash to warn you of the "Enabled" state.
Note 2: Programs can only be saved in the User locations ("050" to "099" in the "A" Bank and "100" to "199" in the "B"
Bank). If you attempt to save a program into any of the Factory ROM locations ( "000" to "049" in the "A" Bank ) the display
digits will flash rapidly to warn that this operation cannot be competed.
Factory Programs
The Super Bass Station comes pre loaded with 200 sounds. The first 50 in the "A" bank are ROM sounds ( Read Only
Memory ) and these cannot be erased. All the other sounds in banks "A" and "B" are in RAM and can be overwritten or
erased. The Super Bass Station can "Recall" all these sounds, reloading the factory sounds into the RAM. You can do this
at any time simply by switching the power off and pressing the "Save" and the "Write" buttons simultaneously and while
holding them down switch the power to the Super Bass Station back on. This will reload all the factory sounds.
NOTE: Doing this will erase permanently any sounds that are in the Super Bass Station and replace them with the factory
sounds. To "Save" any special sounds you might have made refer to Mode 5 - Save System Exclusive Data Dumps on
page 62.
11