Table of Contents
Advertisement
Safety
EN
PLEASE NOTE
Appliance damage caused by incorrect wiring
The electrical safety of the appliance is only
guaranteed if it is connected to a protective
conductor system that has been installed in line
with regulations. Ensure that this basic safety
precaution is met. The appliance must be suitable
for the regional voltage and frequency.
Check the information on the identification plate
u
and in the event of deviations, do not connect the
appliance.
Do not connect the appliance to the mains until
u
the duct system has been installed or the
recirculation filter has been fitted.
Only use the connection cables supplied.
u
PLEASE NOTE
Appliance damage caused by incorrect safety
clearances
Failure to adhere to safety clearances can lead to
damage to the appliance and kitchen units, as well
as restricted functions.
During installation maintain the minimum
u
clearance stated in the chapter.
2.3.1
Safety instructions – cooktop
extractor installation
ö
DANGER
Risk of smoke inhalation
When the cooktop extractor is used in exhaust air
mode, it draws in air from the room it is installed in
and from neighbouring rooms. Without sufficient air,
there will be a drop in air pressure. When used at
the same time as a fireplace that is dependent on
the air in the room, noxious gases can be sucked
into the living areas from the chimney or outlet
shaft.
Make sure that there is always a sufficient air
u
supply.
Only use reliable, tried-and-tested switching
u
devices, (e.g. window contact switch, low
pressure warning device) and have them
approved by a qualified expert (certified chimney
sweep).
6
ö
WARNING
Risk of injury due to turning fan wheel
There is a risk of injury while the fan is turning.
Only install the device with the power
u
disconnected.
Connect both sides of the fan to the duct system
u
before commissioning.
CAUTION
Risk of injury due to turning fan wheel
The vicinity of the fan can be reached if the exhaust
air system has short, straight ducts.
In the case of ducts measuring less than 900
u
mm, a safety guard must be fitted (available as an
accessory).
2.3.2
Safety information for cooktop
installation
ö
DANGER
Risk of electric shock from damaged power
supply cable
If the power supply cable is damaged (e.g. during
installation or by coming into contact with hot
cooking surfaces), this can cause an (lethal) electric
shock.
Make sure that the connection cable does not
u
become trapped or damaged.
Make sure that the power supply cable does not
u
come into contact with hot cooking surfaces.
ö
DANGER
Risk of electric shock from incorrect mains
connection
Connecting the appliance to the mains incorrectly
poses a risk of electric shock.
Make sure that the appliance has a fixed
u
connection to the mains voltage.
Make sure that the appliance is connected to a
u
properly installed protective conductor system.
Make sure that technical equipment is provided
u
to enable all of the appliance's poles to be
disconnected from the mains with a contact
opening width of at least 3 mm (circuit breaker
and automatic circuit breakers, fuses, contactor).
www.bora.com
Advertisement
Table of Contents
