bora Professional 3.0 Installation Instructions Manual page 36

Installation
EN
Fig. 4.64 Connection diagram for the external switch contacts
u Remove the snap-out element required for the cable feed from the
plastic housing of the control unit.
1
Fig. 4.65 Home Out contacts with strain relief
[1] Strain relief clamp
Snap-out element for cable feed
[2]
u Clamp the connection cable in the strain relief clamp provided in
accordance with the wire cross section or number of cables used.
u Check the correct installation, as well as the firm positioning of the
connection cables.
u Close and secure the control unit cover.
u Screw down the lid with the screw provided (max. 2 Nm).
u Make sure that the cable is not damaged or trapped.
u If the Home-In interface is connected to PKAS3/PKAS3AB, the two
insulated wires of the connection cable must be joined together
with a cable tie.
36
2
Fig. 4.66 PKAS3 Home-In interface cable tie
[1] Cable tie
[2] Home-In interface PKAS3/PKAS3AB
Insulated wire
[3]
1
Fig. 4.67 Home Out contacts with strain relief
Strain relief clamp
[1]
[2] Snap-out element for cable feed
1 1
Fig. 4.68 Fitting the strain relief clamp
[1] Strain relief clamp
1 2
3
2
1
www.bora.com