Table of Contents
Advertisement
1
Fig. 4.55 Inserting the Tepan stainless steel grill
[1]
Worktop cut-out
[2]
Tepan stainless steel grill
[3]
Control knob and automatic extractor function ports
u
If applicable, insert the height adjustment plates.
u
Secure the appliance using the mounting brackets.
Screw on the mounting brackets using the washer to a maximum
u
of 2 Nm.
u
Verify that the alignment is correct.
1
4
Fig. 4.56 Mounting brackets
Mounting bracket
[1]
[2]
Washer
[3]
Screw
[4]
Screw (60 mm)
www.bora.com
2
3
2
3
4.11.4 Cooktop installation rotated by
180°
When installing a cooktop with a cooktop extractor, the
configuration cannot be changed to the installation set-up
rotated by 180°.
Safety clearances for cooktops PKC3, PKCB3 and PKCH3
when installed rotated by 180°
2
Fig. 4.57 Required clearance
[1]
Required clearance
Worktop cut-out
[2]
Installation rotated by 180°
For the installation, proceed as described above.
u
u
Change the installation direction in the configuration menu (see
"Configuration menu" in the operating instructions).
T
If installation is rotated by 180°, the ports for the control knobs
and the automatic extractor function are at the rear of the
cooktops.
Gas cooktop installation rotated by 180°
u
Rotate the gas elbow fitting 180° so that the supply can be
connected to the rear.
Tepan stainless steel grill installation rotated by 180°
T
If installation is rotated by 180°, then on the Tepan stainless steel
grill PKT3 the ports for the control knobs and the automatic
extractor function are at the front.
4.12
Connecting external switch
contacts
The electronic unit can contain residual charge. You must therefore
be careful not to touch the exposed contacts on the electronic unit.
When using Home In and Home Out, you will require the relevant
documents for the external switch devices in order to ensure safe
device connection and operation. The following switch contacts can
be used:
Installation
1
EN
33
Advertisement
Table of Contents
