Table of Contents
Advertisement
4.13
Establishing communication
and power connection
T
The plug for the mains supply cable must be accessible following
installation.
T
If the mains supply cable has been damaged this must be replaced.
T
The appliance components are linked by the ribbon cable provided.
4.13.1 Connecting the control knobs
Control knobs must only be connected to the ports provided on the
appliance.
u
Connect the control knobs to the appliances.
1
Fig. 4.69 Back of control knob with port
[1]
Port on the back of the control knob
Connecting the control knobs to the cooktop extractor
u
Connect the port on the back of the control knob to the port
provided on the side of the cooktop extractor.
Fig. 4.70 Ports on the side of the cooktop extractor
Control knob port
[1]
Connecting the control knobs to the cooktop
In the normal set-up the ports are on the front of the cooktops.
According to the default settings, the left control knob operates the
front cooking zone (zone 1) and the right control knob operates the
rear cooking zone (zone 2).
Connect the port on the back of the left control knob to the "zone
u
2" port on the cooktop.
u
Connect the port on the back of the right control knob to the "zone
1" port on the cooktop.
www.bora.com
Using the configuration menu, set the correct allocation of the
u
cooking zones in the control knob display (see "Configuration
menu" in the operating instructions).
Fig. 4.71 Ports on the cooktop
[1]
Front cooking zone control knob port (zone 1)
[2]
Extractor electronics interface port
[3]
Rear cooking zone control knob port (zone 2)
1
Fig. 4.72 Standard connection of appliances that connect at the front
[1]
Cooktop
[2]
Rear cooking zone (zone 2)
[3]
Front cooking zone (zone 1)
Rear cooking zone control knob (zone 2)
[4]
[5]
Front cooking zone control knob (zone 1)
Installation
1
2
3
5
4
EN
1
2
3
37
Advertisement
Table of Contents
