Table of Contents
Advertisement
Remove the pan support.
u
u
Remove the burner cap from the burner head.
u
Remove the burner head from the gas outlet.
Fig. 4.48 Gas burner structure
[1]
Burner cap
[2]
Burner head
[3]
Electric igniter
[4]
Safety thermocouple
[5]
Burner housing
[6]
Gas burner nozzle
u
Unscrew the gas burner nozzle from the gas burner
u
Screw the corresponding nozzle for the gas type to be used into
the gas burner.
u
Put the burner parts back together again.
u
Position the burner head correctly on the gas outlet.
u
Ensure that the safety thermocouple and the electric igniter are
positioned in the correct opening.
Position the burner cap so that it fits perfectly, sitting straight on
u
the burner head.
T
If burner parts are not positioned correctly, the electric igniter will
not work.
Place the pan support straight on the gas burner so it fits perfectly.
u
Fig. 4.49 Cooktop burner with gas burner nozzle
Gas burner
[1]
[2]
Gas burner nozzle
www.bora.com
Set the gas type in the configuration menu.
u
Affixing the nozzle set nameplates
Affix the nozzle set nameplates included in the scope of delivery in
the corresponding space over the nozzle set nameplate on the
bottom of the cooktop and on the penultimate page of the operating
instructions.
1
2
3
4
5
Fig. 4.50 Affixing the nozzle set nameplates
6
4.11
Installing the cooktops
Clearance of one millimetre should be planned between the built-in
appliances. A clearance of two millimetres should be planned around
the built-in appliances.
Clearance of one millimetre should be planned between the built-in
appliances. A clearance of two millimetres should be planned around
the built-in appliances.
The cooktop can also be installed rotated by 180°.
4.11.1 Preparing the cooktop extractor
when using the wok cooktop
If a cooktop extractor is right next to a wok cooktop, the plastic bar
on the side of the cooktop extractor must be carefully removed.
u
Carefully remove the plastic bar from the side of the cooktop
extractor.
u
To do this, use a utility knife or similar suitable tool.
1
2
Installation
EN
31
Advertisement
Table of Contents
