Table of Contents
Advertisement
Installation
EN
u
Switch on the main switch/automatic circuit breaker.
u
Put the cooktop into operation (see the operating instructions).
u
Check that all the functions are working correctly.
4.14
Basic configuration
When installation is complete, you must carry out the basic settings
(these settings can be changed at any time later on). You can see
precise instructions on the basic configuration and all necessary
information in the operating instructions.
4.14.1 Gas configuration
The burner nozzles, gas type and pressure may only be
changed by a certified engineer or BORA service technician.
They also assume responsibility for the proper gas installation
and commissioning.
Gas characteristic curve A must not be used in the case of
liquid gas (G30/31).
It is important that the gas type, gas pressure and
characteristic curve are set correctly to ensure safe, failure-
free operation of the gas cooktop.
You can see detailed information on the configuration menu
in the operating instructions.
4.15
Initial operation
Ensure that all appliances are connected correctly and connected
u
to the power supply (fused) prior to initial operation.
T
Exception: during initial operation, the kitchen fitter may use a
temporary power supply for the control unit in order to configure
the appliance (e.g. using the site power supply during the building
phase).
T
The settings made are saved and will not be affected when the
system is disconnected from the mains.
T
The final mains connection to the appliances may only be set up by
certified specialists.
Carry out a thorough function test on all appliances.
u
In the event of error messages, see the "Troubleshooting" chapter.
u
4.15.1 Using the gas cooktop for the first
time
Initial operation is possible when the gas cooktop has been fully
installed and configured.
Function test on the gas cooktop
Switch the cooking zone on.
u
The electronic gas regulator will calibrate itself (humming noises) and
then the gas flame will automatically ignite in the selected cooking
zone. The gas flame will burn steadily and evenly.
Using the gas cooktop together with the cooktop
extractor for the first time
Switch the cooktop extractor to the maximum power level.
u
u
Switch all cooking zones to the minimum power level.
42
The electronic gas regulator will calibrate itself (humming noises) and
then the gas flame will automatically ignite in the selected cooking
zone. The gas flame will burn steadily and evenly (no reignition). The
gas flame will be slightly affected by the cooktop extractor (airflow) –
this is normal.
u
Carry out a thorough function test on all appliances.
u
In the event of error messages, see the "Troubleshooting" chapter.
4.16
Sealing the appliances
Once all of the installation work and initial operation is complete,
u
seal the appliances all the way round (also between the cooktop
extractor and cooktop) with black, heat-resistant silicone sealant.
u
Make sure that no silicone sealant gets under the cooktop.
1
Fig. 4.87 Silicone sealant for flush installation
[1]
Black, heat-resistant silicone sealant
1
Fig. 4.88 Silicone sealant for surface mounting
[1]
Black, heat-resistant silicone sealant
4.17
Handover to user
Once installation is complete:
u
Explain the main functions to the user.
u
Explain all safety-related aspects of operation and handling to the
user.
Provide the user with the accessories and operating and
u
installation instructions, which are to be kept in a safe place.
u
Affix the identification plates provided to the penultimate page in
the operating instructions.
If a gas cooktop is installed:
u
also affix the nozzle set identification plate to the penultimate page
of the gas cooktop operating instructions.
www.bora.com
Advertisement
Table of Contents
