Table of Contents
Advertisement
2
1
Fig. 4.32 Height adjustment plates
[1]
Height adjustment plate
[2]
Cooktop extractor
u
The cooktop extractor is to be installed 0.5 mm higher than the
cooktops.
1
Fig. 4.33 Height difference
[1]
Cooktop
[2]
Cooktop extractor
4.8.2
Securing the cooktop extractor
Preparing the mounting brackets
The cooktop extractor is secured using the four mounting brackets
provided. The symbols on the mounting brackets show which side to
use for surface mounting and which to use for flush installation. The
lettering shows the cutting mark corresponding to the worktop
thickness.
u
If necessary, shorten the mounting brackets according to the
thickness of the worktop.
u
To do this, cut the mounting brackets at the appropriate cut marks
using a utility knife.
u
Depending on the installation type, turn the mounting brackets to
the left or right (flush installation or surface mounting).
www.bora.com
2
1
Fig. 4.34 Mounting bracket – right side (flush installation)
[1]
Worktop thickness lettering (in mm)
[2]
Cut marks (x 4)
[3]
Fastening lugs (2 on each side)
Marking for flush installation
[4]
Fig. 4.35 Mounting bracket – left side (surface mounting)
[1]
Worktop thickness lettering (in mm)
[2]
Cut marks (x 4)
[3]
Fastening lugs (2 on each side)
[4]
Marking for surface mounting
Securing the cooktop extractor
u
Push the mounting brackets into the holders provided on the
cooktop extractor or the alternative positions on the holding plate.
Installation
EN
1
2
3
4
1
2
3
4
25
Advertisement
Table of Contents
