Table of Contents
Advertisement
Installation
EN
2
Fig. 4.27 Turning the curved duct piece over
[1]
Curved duct piece
[2]
Duct piece adapter
u
Make sure that no air gap has formed between the components.
u
Attach the holding plate.
Fig. 4.28 Airflow to the left with the curved duct piece
4.7.3
Rotating the cover frame by 180°
To ensure correct orientation of the cover frame, this must also be
rotated by 180°.
Turn the cooktop extractor round and lay it carefully on a soft
u
surface (e.g. a blanket) with the visible surface facing upwards.
u
Carefully remove the holding clamps (x 18) with a screwdriver.
Fig. 4.29 Removing the cover frame
Turn the cooktop extractor round and remove the cover frame.
u
u
Rotate the cover frame by 180°.
u
Put the cover frame back on the cooktop extractor.
u
Make sure that the holding clamps click into place.
24
1
Fig. 4.30 Removing the cover frame
[1]
[2]
4.8
Clearance of one millimetre should be planned between the built-in
appliances. A clearance of two millimetres should be planned around
the built-in appliances.
4.8.1
u
u
Fig. 4.31 Fitting the cooktop extractor
[1]
[2]
u
1
Cover frame
Cooktop extractor
Installing the cooktop
extractor
Fitting the cooktop extractor
Place the cooktop extractor in the middle of the worktop cut-out
provided.
Position the cooktop extractor with precision.
Worktop cut-out
Cooktop extractor
If applicable, insert the height adjustment plates.
2
1
2
www.bora.com
Advertisement
Table of Contents
