Table of Contents
Advertisement
Installation
EN
Fig. 4.51 Plastic bar on the side of the cooktop extractor
Plastic bar on the side
[1]
[2]
Cooktop extractor
4.11.2 Installing the cooktop
When installing cooktops PKFI3 and PKI3, pay attention to the
position of the cooktop display (alternatively, the cooktop can be
installed rotated by 180°).
Insert the cooktop into the worktop cut-out.
u
u
Precisely align the cooktop.
u
For a normal installation, please note that the ports for the control
knobs and the automatic extractor function are at the front.
u
The connection cables should be guided to the rear. Use the cable
holders provided.
1
Fig. 4.52 Inserting the cooktop
Control knob port and cooktop extractor interface (front)
[1]
[2]
Cooktop
[3]
Worktop cut-out
u
If applicable, insert the height adjustment plates.
32
1
2
2
3
Fig. 4.53 Cooktop and height adjustment plates
[1]
Cooktop
Height adjustment plates
[2]
u
Secure the appliance using the mounting brackets.
u
Screw on the mounting brackets using the washer to a maximum
of 2 Nm.
Verify that the alignment is correct.
u
1
3
Fig. 4.54 Mounting brackets
[1]
Mounting bracket
[2]
Washer
[3]
Screw
4.11.3 Installing the Tepan stainless steel
grill
u
Insert the Tepan stainless steel grill into the worktop cut-out.
u
Precisely align the Tepan stainless steel grill.
u
For a normal installation, please note that the ports for the control
knobs and the automatic extractor function are at the rear.
1
2
2
www.bora.com
Advertisement
Table of Contents
