Table of Contents
Advertisement
Installation
EN
Wok cooktop with 1 control knob
1
Fig. 4.18 Drilling pattern for wok cooktop with 1 control knob
[1]
Wok cooktop PKIW3
[2]
Worktop
[3]
Fixed front panel
4.6.3
Example bore holes
3
1
2
Fig. 4.19 Drilling pattern for 2 cooktops, 1 cooktop extractor and 2
sockets
[1]
Boreholes for socket (x 2 external)
[2]
Bore holes for control knobs (x 5)
[3]
Cooktop (x 2)
[4]
Cooktop extractor
[5]
Worktop
[6]
Fixed front panel
1
2
3
4
Fig. 4.20 Drilling pattern for 3 cooktops, 2 cooktop extractors and 2
sockets
22
2
4
3
3
4
3
Boreholes for socket (x 2 external)
[1]
[2]
Bore holes for control knobs (x 8)
[3]
Cooktop (x 3)
[4]
Cooktop extractor (x 2)
[5]
Worktop
3
[6]
Fixed front panel
4.6.4
Fitting the control knob
u
Remove the knob ring.
Unscrew the universal nut.
u
u
Remove the wave spring.
u
Insert the knob housing from the front through the hole in the
panel.
u
Attach the wave spring to the knob housing.
T
In the case of steel fronts, wave springs must not be used.
Screw the universal nut onto the knob housing from the rear and
u
tighten a little.
u
Align the knob housing so it is level.
u
Tighten the universal nut.
T
The wave spring must be pressed flat.
Remove the sticker.
u
u
Place the knob ring on the knob housing.
5
6
5
4
3
Fig. 4.21 Structure of control knob
[1]
Knob housing
[2]
Universal nut
[3]
Sticker
[4]
Knob ring
[5]
Wave spring
5
6
Fig. 4.22 Fitting the control knob
1
2
www.bora.com
Advertisement
Table of Contents
